How do I remove jump bars from my skates? Jump bars can be removed from plates however it is not recommended by manufacturers as removing the jump bar can interfere with the structural support of the plate.
How do I get the old bearings out of my existing wheels? You will need a Reflex Tool . You can use this tool to remove wheels from you skates and use it to remove bearings from the wheels. Use it for quick extraction of the axle bolt once it's loose.. It is
How easy is it to change your wheels? It is very easy to change your wheels. You will need the replacement set of wheels with the bearings already in them and a skate tool. Remove the wheel by using the skate tool. Remember, righty tighty
How to Heat Mold your Vanilla Speed Inline Skates. All Vanilla Speed boots are easily molded for increased comfort and performance. We have specifically designed our speed inline boots to fit tight rather than loose, as it is much easier to make a boo
How do I change the wheels on my quad skates? *Unscrew the nut from each wheel with your skate tool. Place the tool over the nut, and turn it counterclockwise until the nut comes off.
*Remove the wheels from their bolts.
*Put the new wheels
What type of maintenance is there do to my Toe stops? Non adjustable bell-type stoppers: On a weekly basis it is very important to verify that the toe stoppers are tightly fastened (vibration from stopping frequently will loosen the toe stoppers). To tig
How do you attach toe caps to your skates? Toe-savers Instructions
1. Remove toe stop,slip toe cap over skate to measure which lace to loop strap under.
2. Hold toe cap over the skate and loop strap under the lace and snap.
3. Put toe cap o
